Mini Touch Kit
SEN0104
₱407.00₱285.00
Out of stock
Introduction
This is a cool touch sensor from DFRobot. You can hook it up to the IO Expansion shield (for arduino) directly. It includes a metallic tape with a sticky side. This make it possible for you to place your sensors anywhere you want. So, if you get sick of the typical push buttons, try this invisible button for your projects! This touch sensor works on a variety of surfaces; Metal, glass, plastic, rubber. It does not work on cardboard or wood.
NOTE:This sensor requires some basic soldering.
Specification
Power supply: 3.3-5v
Dimension: 15 10 mm/0.6 0.39 inches
Pin definition:
Digital output(Green wire)
Power(Red wire)
GND(Black wire)
Documents
Package List
ITA-Touch module with Digital sensor cable x1
3x3cm copper with the sticky part x1
15cm wire x1
SUR+ (Unused )
Generally New Old Stock (NOS) -- items that remain unused or sealed. These may be older models or have packaging that shows handling, but the product itself has not been used.
USED
Pre-owned items that have been previously operated. They may show signs of wear but remain fully functional. Sold as-is unless otherwise specified.
REFURBISHED
Previously owned items that have been tested, repaired (if necessary), and restored to good working condition. Cleaned and inspected to ensure dependable performance.